especially those without power factor correction, cannot be run from a generator. However newer models have internal circuitry that allow units withour power factor correct to run on generators.

The HF Contact type typically found in budget machines uses a high frequency high voltage spark to ionise the air through the torch head and initiate an arc. The arc can only be formed if the torch is in contact with the job material. HF Contact type machines are not suitable for applications involving CNC cutting.

A specialized use of CNC controlled Plasma Cutters has been in the HVAC industry. Software will process information on ductwork and create flat patterns to be cut on the cutting table by the plasma torch. This technology has enormously increased productivity within the industry since its introduction in the early 1980s.