Analog plasma cutters, typically requiring more than 2 kilowatts, use a heavy mains frequency transformer. Inverter plasma cutters rectify the mains voltage into DC, which is fed into either an IGBT or a MOSFET. IGBT transistors operate independently of one another whilst MOSFET transistors need to be paralleled. With paralleled MOSFET transistors if one of the transistors activates prematurely it can lead to a cascading failure of one quarter of the inverter. IGBT transistors do not have this problem as they are independent however are very expensive to manufacture and generally used in high current machines where it is not possible to parallel sufficient MOSFET transistors. The transistors are switched at thousands of Hertz, which greatly reduces the magnetic flux in the step down transformer, and therefore the size of the transformer is reduced accordingly. The switch mode topology is referred to as a dual transistor off-line forward converter.

Since plasma cutters produce a very hot and very localized 'cone' to cut with, they are extremely useful for cutting sheet metal in curved or angled shapes.

Plasma is an effective means of cutting thin and thick materials alike. Hand held torches can usually cut up to 2 in (48 mm) thick steel plate, and stronger computer-controlled torches can pierce and cut steel up to 12 inches (300 mm) thick. Formerly, plasma cutters could only work on conductive materials, however new technologies allow the plasma ignition arc to be enclosed within the nozzle thus allowing the cutter to be used for non-conductive workpieces.