especially those without power factor correction, cannot be run from a generator. However newer models have internal circuitry that allow units withour power factor correct to run on generators.

Since plasma cutters produce a very hot and very localized 'cone' to cut with, they are extremely useful for cutting sheet metal in curved or angled shapes.

The Pilot Arc type uses a two cycle approach to producing plasma. First, a high-voltage, low current circuit is used to initialize a very small high intensity spark within the torch body, thereby generating a small pocket of plasma gas. This is referred to as the pilot arc. The pilot arc has a return electrical path built into the torch head. The pilot arc will maintain until it is brought into proximity of the workpiece where it ignites the main plasma cutting arc. Plasma arcs are extremely hot and are in the range of 15,000 degrees Celsius.