Analog plasma cutters, typically requiring more than 2 kilowatts, use a heavy mains frequency transformer. Inverter plasma cutters rectify the mains voltage into DC, which is fed into either an IGBT or a MOSFET. IGBT transistors operate independently of one another whilst MOSFET transistors need to be paralleled. With paralleled MOSFET transistors if one of the transistors activates prematurely it can lead to a cascading failure of one quarter of the inverter. IGBT transistors do not have this problem as they are independent however are very expensive to manufacture and generally used in high current machines where it is not possible to parallel sufficient MOSFET transistors. The transistors are switched at thousands of Hertz, which greatly reduces the magnetic flux in the step down transformer, and therefore the size of the transformer is reduced accordingly. The switch mode topology is referred to as a dual transistor off-line forward converter.

Since plasma cutters produce a very hot and very localized 'cone' to cut with, they are extremely useful for cutting sheet metal in curved or angled shapes.

A specialized use of CNC controlled Plasma Cutters has been in the HVAC industry. Software will process information on ductwork and create flat patterns to be cut on the cutting table by the plasma torch. This technology has enormously increased productivity within the industry since its introduction in the early 1980s.